R&S ESR Series User Manual page 320

®
R&S ESR
# of Samples ← APD
Opens an edit dialog box to set the number of power measurements that are taken into
account for the statistics.
Apart from the number of measurements the overall measurement time depends also
on the set resolution bandwidth as the resolution bandwidth directly influences the
sampling rate.
For details see
Remote command:
CALCulate<n>:STATistics:NSAMples
Scaling ← APD
Opens a submenu to change the scaling parameters of x- and y-axis.
x-Axis Ref Level ← Scaling ← APD
Opens an edit dialog box to enter the reference level in the currently active unit (dBm,
dBµV, etc). The function of this softkey is identical to the "Ref Level" softkey in the
"Amplitude" menu (see
For the APD function this value is mapped to the right diagram border. For the CCDF
function there is no direct representation of this value on the diagram as the x-axis is
scaled relatively to the measured mean power.
Remote command:
CALCulate<n>:STATistics:SCALe:X:RLEVel
x-Axis Range ← Scaling ← APD
Opens the "Range" submenu to select a value for the level range to be covered by the
statistics measurement selected.
Remote command:
CALCulate<n>:STATistics:SCALe:X:RANGe
Range Log 100 dB ← x-Axis Range ← Scaling ← APD
Sets the level display range to 100 dB.
Remote command:
Logarithmic scaling:
DISP:WIND:TRAC:Y:SPAC LOG, see
SPACing
Display range:
DISP:WIND:TRAC:Y 100DB, see
on page 844
Range Log 50 dB ← x-Axis Range ← Scaling ← APD
Sets the level display range to 50 dB.
Remote command:
Logarithmic scaling:
DISP:WIND:TRAC:Y:SPAC LOG, see
SPACing
User Manual 1175.7068.02 ─ 12
"Selecting the number of samples"
"Ref Level"
on page 668
on page 668
on page 313.
on page 793
on page 352).
on page 798
on page 797
DISPlay[:WINDow<n>]:TRACe<t>:Y:
DISPlay[:WINDow<n>]:TRACe<t>:Y[:SCALe]
DISPlay[:WINDow<n>]:TRACe<t>:Y:
Spectrum Measurements
Measurements
317