R&S ESR Series User Manual page 795

®
R&S ESR
● Configuring Statistical
● Retrieving
● Using Gate Ranges for Statistical
● Scaling the
Configuring Statistical Measurements
The following commands configure the measurement.
CALCulate<n>:STATistics:APD[:STATe]
CALCulate<n>:STATistics:CCDF[:STATe]
CALCulate<n>:STATistics:NSAMples
CALCulate<n>:STATistics:APD[:STATe] <State>
This command switches on or off the measurement of amplitude distribution (APD). On
activating this function, the CCDF measurement is switched off.
Suffix:
<n>
Parameters:
<State>
Example:
Manual operation:
CALCulate<n>:STATistics:CCDF[:STATe] <State>
This command switches on or off the measurement of the complementary cumulative
distribution function (CCDF). On activating this function, the APD measurement is
switched off.
Suffix:
<n>
Parameters:
<State>
Example:
Manual operation:
User Manual 1175.7068.02 ─ 12
Measurements...................................................................792
Results................................................................................................. 793
Diagram..............................................................................................796
............................................................................792
......................................................................... 792
............................................................................... 793
.
irrelevant
ON | OFF
*RST: OFF
CALC:STAT:APD ON
Switches on the APD measurement.
See "APD" on page 224
See "APD" on page 316
.
irrelevant
ON | OFF
*RST: OFF
CALC:STAT:CCDF ON
Switches on the CCDF measurement.
See "CCDF" on page 224
See "CCDF" on page 321
Remote Commands in Spectrum Analyzer Mode
Measurements................................................ 794
Remote Control
792