R&S ESR Series User Manual page 640

®
R&S ESR
● Test
● Working with
● Limit
11.4.1 Measurements and Result Displays
● Display
● Bargraph
● Scan
● Final Measurements and Automated Test Sequence
● Trace Data and Result
● Fixed Frequency
● Demodulating Analog
● Spectrogram
11.4.1.1 Display Configuration
CALCulate<n>:FEED
CALCulate<n>:FEED <ResultDisplay>
This command selects the result display.
Suffix:
<n>
Parameters:
<ResultDisplay>
11.4.1.2 Bargraph Control
DISPlay:BARGraph:LEVel:LOWer?
DISPlay:BARGraph:LEVel:UPPer?
DISPlay:BARGraph:PHOLd[:STATe]
User Manual 1175.7068.02 ─ 12
Automation.................................................................................................... 673
Markers............................................................................................687
Lines............................................................................................................. 703
Configuration............................................................................................ 637
Control...................................................................................................637
Control......................................................................................................... 640
Query............................................................................... 643
Scans........................................................................................ 647
Signals...............................................................................648
Control............................................................................................. 649
..................................................................................................... 637
.
1...3
Selects the measurement window.
'NONE'
Removes the window selected with the suffix <n>.
'XTIM:SPECtrum'
Selects the IF analysis result display.
'XTIM:BARGraph'
Selects the bargraph.
Note that the Bargraph always has to be in window 1.
'XFRequency[:SPECtrum]'
Selects the scan result display.
'XFRequency:SGRam'
Selects the spectrogram result display.
Note that you can add a spectrogram only if you have already
turned on either Scan or IF Analysis. If you are displaying Scan
and IF Analysis simultaneously, the Spectrogram is unavailable.
Remote Commands in Receiver Mode
..................................................................................638
.................................................................................. 638
.................................................................................638
Remote Control
Control...............................642
637