R&S ESR Series User Manual page 271

®
R&S ESR
Result Evaluation
As a result of the Spectrum Emission Mask measurement, the measured signal levels,
the result of the limit check (mask monitoring) and the defined limit line are displayed in
a diagram (see also
Furthermore, the TX channel power "P" is indicated in relation to the defined power
class ranges.
Example:
For example, "P<31" is indicated if the lowest power class is defined from infinity to 31
and the power is currently 17 dBm.
In addition to the graphical results of the SEM measurement displayed in the diagram,
a result table is displayed to evaluate the limit check results (see also
Limit Lines in SEM Measurements"
The following information is provided in the result table:
Label
General Information
Standard
Tx Power
Tx Bandwidth
RBW
Range results
Range Low
User Manual 1175.7068.02 ─ 12
"Working with Limit Lines in SEM Measurements"
on page 271).
Description
Loaded standard settings
Tx channel power
Tx channel bandwidth
RBW for the Tx channel
Frequency range start for range the peak value belongs to
Spectrum Measurements
Measurements
on page 271).
"Working with
268