R&S ESR Series User Manual page 997

®
R&S ESR
Example:
Manual operation:
11.16 Status Register
For more information on the contents of the status registers see the following sections.
Status registers in receiver mode:
●
"STATus:OPERation Register"
●
"STATus:QUEStionable Register"
●
"STATus:QUEStionable:FREQuency Register"
●
"STATus:QUEStionable:LIMit Register"
●
"STATus:QUEStionable:LMARgin Register"
●
"STATus:QUEStionable:POWer Register"
●
"STATus:QUEStionable:TRANsducer Register"
Status registers in spectrum mode:
●
"STATus:OPERation Register"
●
"STATus:QUEStionable Register"
●
"STATus:QUEStionable:ACPLimit Register"
●
"STATus:QUEStionable:FREQuency Register"
●
"STATus:QUEStionable:LIMit Register"
●
"STATus:QUEStionable:LMARgin Register"
●
"STATus:QUEStionable:POWer Register"
11.16.1 General Status Register Commands
STATus:PRESet
STATus:QUEue[:NEXT?]?
User Manual 1175.7068.02 ─ 12
ENHanced
If subsequent commands are not found on the same tree level
as the previous command, the SCPI parser searches "back-
wards up the tree" of defined SCPI commands. If the command
is found at a higher node, that command is used. Only if the
command is not found anywhere, an error message is returned.
*RST: setting is retained
*RST
:SYSTem:TWALKing ENHanced
:SENSe:SWEep:MODE LIST
INIT:CONT OFF
LIST:RANG4:DEL;RANG3:DEL
//without enhanced tree walking this command would deliver an
error
See "Tree Walking"
on page 580
on page 586
.............................................................................................................995
...............................................................................................995
on page 517
on page 581
on page 582
on page 582
on page 583
on page 584
on page 584
on page 587
on page 588
on page 582
on page 582
on page 583
on page 584
Remote Control
Status Register
994