R&S ESR Series User Manual page 754

®
R&S ESR
Example:
Manual operation:
[SENSe:]LIST:RANGe<range>:BANDwidth:VIDeo
This command sets the VBW value for the specified range.
Suffix:
<range>
Parameters:
<Value>
Example:
Manual operation:
[SENSe:]LIST:RANGe<range>:BREak <State>
This command configures the sweep behavior.
The suffixes are irrelevant.
Suffix:
<range>
Parameters:
<State>
Example:
Manual operation:
[SENSe:]LIST:RANGe<range>:COUNt
This command returns the number of defined ranges.
Suffix:
<range>
User Manual 1175.7068.02 ─ 12
Remote Commands in Spectrum Analyzer Mode
LIST:RANG2:BAND:RES 5000
Sets the RBW for range 2 to 5 kHz.
See "RBW" on page 290
.
1...20
range
Refer to the data sheet.
*RST: 10.0 MHz
LIST:RANG1:BAND:VID 5000000
Sets the VBW for range 1 to 5 MHz.
See "VBW" on page 290
.
1...20
range
ON
The R&S ESR stops after one range is swept and continues only
if you confirm (a message box is displayed).
OFF
The R&S ESR sweeps all ranges in one go.
*RST: OFF
LIST:RANG:BRE ON
Configures a stop after each range.
See "Stop After Sweep"
.
1...20
range
Remote Control
on page 291
751