R&S ESR Series User Manual page 488

®
R&S ESR
Generator
HP ESG-A Ser-
ies 1000A,
2000A, 3000A,
4000A
HP ESG-D
SERIES
E4432B
1) Requires the option SMR-B11 to be fitted.
2) Maximum/minimum power depends on presence of Option SMR-B15/-B17 and set frequency range. For
more details see SMR data sheet.
3) Maximum/minimum power depends on presence of Option SMP-B15/-B17 and set frequency range. For
more details see SMP data sheet.
4) Requires firmware version V3.20.200 or higher on the signal generator
8.3 Configuring Tracking Generators
The "Tracking Generator Configuration" dialog box is opened via the "Source Config"
softkey in the "Tracking Generator" menu.
This dialox box allows you to define measurement settings, as well as connection set-
tings for the optional external generators (option B10 only). Depending on which
options are installed, the corresponding tabs for internal or external generators, or
both, are displayed.
●
Chapter 8.3.1, "Internal Tracking
●
Chapter 8.3.2, "External Tracking
8.3.1 Internal Tracking Generator
The internal tracking generator is configured in the "Internal" tab of the "tracking Gen-
erator Configuration" dialog box.
In the top half of the dialog box, the measurement configurations can be defined. In the
lower half of the dialog box, the capabilities of the internal tracking generator are dis-
played for reference only.
User Manual 1175.7068.02 ─ 12
Interface Type Generator Min
Freq
GPIB 250 kHz
GPIB 250 kHz
Generator",
Generator",
Tracking Generator
Configuring Tracking Generators
Generator Max Generator Min
Freq Power
dBm
4 GHz -136
3 GHz -136
on page 485
on page 487
Generator Max
Power
dBm
20
+10
485