R&S ESR Series User Manual page 799

®
R&S ESR
Parameters:
<State>
Example:
Manual operation:
[SENSe:]SWEep:EGATe:TRACe<k>: STOP<range> <Value>
This command defines the stopping point for the range to be traced using gated trig-
gering
Suffix:
<k>
<range>
Parameters:
<Value>
Example:
Manual operation:
Scaling the Diagram
The following commands configure the diagram for statistical measurements.
CALCulate<n>:STATistics:PRESet
CALCulate<n>:STATistics:SCALe:AUTO ONCE
CALCulate<n>:STATistics:SCALe:X:RANGe
CALCulate<n>:STATistics:SCALe:X:RLEVel
CALCulate<n>:STATistics:SCALe:Y:LOWer
CALCulate<n>:STATistics:SCALe:Y:UNIT
CALCulate<n>:STATistics:SCALe:Y:UPPer
CALCulate<n>:STATistics:PRESet
This command resets the scaling of the X and Y axes in a statistical measurement.
The following values are set:
x-axis ref level:
x-axis range APD:
x-axis range CCDF:
User Manual 1175.7068.02 ─ 12
Remote Commands in Spectrum Analyzer Mode
ON | OFF
*RST: OFF
SWE:EGAT:TRAC1:STAT1 ON
Activates tracing for range 1 of trace 1.
See "Gate Ranges" on page 320
.
1...6
trace
1...3
range
<numeric value>
*RST: 1 μs
SWE:EGAT:TRAC1:STOP1 5ms
Sets the stopping point for range 1 on trace 1 at 5 ms.
See "Gate Ranges" on page 320
...................................................................................796
................................................................ 797
..................................................................... 797
..................................................................... 798
...................................................................... 798
.........................................................................798
.......................................................................799
Remote Control
-20 dBm
100 dB
20 dB
796