R&S ESR Series User Manual page 412

®
R&S ESR
●
To switch to another marker, click on the marker label in the diagram. Alternatively,
select the corresponding softkey. If necessary, select the
to open a submenu that contains all marker numbers.
●
To move the marker to a different position, click the marker label in the diagram
and then drag it to the new position. When a marker label is selected, a vertical line
is displayed which indicates the marker's current x-value.
●
To switch on a delta marker, select the softkey for the corresponding marker, then
press the "Marker 1 / Marker 2 / Marker 3 / ... Marker 16,/ Marker Norm/Delta"
("Marker 1 / Marker 2 / Marker 3 / ... Marker 16,/ Marker Norm/Delta"
until "Delta" is highlighted.
The selected marker is switched on as a delta marker. The frequency and level of
the marker are displayed in relation to marker 1 in the marker field.
●
To change the marker type of a marker, select the softkey for the corresponding
marker, then press the "Marker 1 / Marker 2 / Marker 3 / ... Marker 16,/ Marker
Norm/Delta" softkey
Norm/Delta"
For a normal marker, the frequency and level are displayed as absolute values in
the marker field. For a delta marker, the frequency and level of the marker are dis-
played in relation to marker 1 in the marker field.
●
To switch off a marker, press the corresponding softkey again.
The marker is deactivated. Marker 1 becomes the active marker for entry. The fre-
quency and level of marker 1 are displayed in the marker field.
●
To switch off all markers, press the
●
To change the stepsize between one measured value and the next when the
marker or delta marker value is changed via the rotary knob, press either the
Stepsize Standard
User Manual 1175.7068.02 ─ 12
("Marker 1 / Marker 2 / Marker 3 / ... Marker 16,/ Marker
on page 201).
softkey or the Stepsize Sweep Points
Spectrum Measurements
More Markers
All Marker Off softkey.
softkey.
Analysis
softkey first
on page 201)
409