R&S ESR Series User Manual page 935

®
R&S ESR
Manual operation:
INPut<ip>:UPORt[:VALue]
This command queries the control lines of the user ports.
For details see
Suffix:
<ip>
Example:
Manual operation:
OUTPut:IF[:SOURce] <Source>
This command selects the source of the IF output.
Parameters:
<Source>
Example:
Manual operation:
OUTPut:TRIGger <PortLevel>
This command selects level of the Trigger Out port. Thus, you can trigger an additional
device via the external trigger port, for example.
Parameters:
<PortLevel>
Example:
User Manual 1175.7068.02 ─ 12
ON | 1
User port is switched to INPut
OFF | 0
User port is switched to OUTPut
*RST: 1
See "User Port"
OUTPut:UPORt[:VALue]
.
1 | 2
irrelevant
INP:UPOR?
//Result: #B00100100
Pins 5 and 7 are active.
See "User Port"
IF
Outputs the intermediate frequency.
OFF
Turns off the output of a signal.
VIDeo
Outputs the video signal (200 mV).
*RST: IF
OUTP:IF VID
Selects the video signal for the IF output connector.
See "Video Output"
LOW | HIGH
*RST: LOW
OUTP:TRIG HIGH
on page 187
on page 933.
on page 187
on page 384
Remote Control
System Configuration
932