Configuring The Sweep Mode - Sweep Key; Softkeys Of The Sweep Menu - R&S ESR Series User Manual

®
R&S ESR
Filter Bandwidth
28 MHz
40 MHz
6.2.7 Configuring the Sweep Mode – SWEEP Key
The SWEEP key is used to configure the sweep mode. Continuous sweep or single
sweep is possible. The sweep time and the number of measured values are set.
To open the Sweep menu
●
Press the SWEEP key.
The "Sweep" menu is displayed.
Menu and softkey description
●
Chapter 6.2.7.1, "Softkeys of the Sweep
Task
●
Chapter 6.2.7.2, "Specifying the Sweep
6.2.7.1

Softkeys of the Sweep Menu

The following table shows all softkeys available in the "Sweep" menu. It is possible that
your instrument configuration does not provide all softkeys. If a softkey is only available
with a special option, model or (measurement) mode, this information is provided in the
corresponding softkey description.
Continuous
Single
Continue Single
Sweeptime
Sweeptime
Sweep
Sweep
Sweep
Select
Continue Frame (On
Frame
Spectrogram
User Manual 1175.7068.02 ─ 12
Sweep...................................................................................................... 370
Sweep.............................................................................................................. 370
Sweep...............................................................................................370
Manual......................................................................................................370
Auto.......................................................................................................... 371
Type................................................................................................................ 371
└ Sweep........................................................................................................... 371
└ FFT............................................................................................................... 371
└ Auto...............................................................................................................371
└ FFT Filter Mode............................................................................................ 372
└ Auto.................................................................................................... 372
└ Narrow................................................................................................ 372
Count...............................................................................................................372
Points.............................................................................................................. 372
Frame...............................................................................................................373
Off).............................................................................................373
Count............................................................................................................... 373
Clear...................................................................................................... 374
Filter Type Application
CFILter
CFILter
Menu", on page 369
Settings", on page 374
Spectrum Measurements
Configuration
369