R&S ESR Series User Manual page 827

®
R&S ESR
[SENSe:]FREQuency:CENTer:STEP:LINK:FACTor <Factor>
This command defines a step size factor if the center frequency step size is coupled to
the span or the resolution bandwidth.
Parameters:
<Factor>
Example:
Manual operation:
[SENSe:]FREQuency:MODE <Mode>
This command selects the frequency mode.
between span > 0 and zero span in the "Spectrum" mode.
Parameters:
<Mode>
Example:
Usage:
[SENSe:]FREQuency:OFFSet <Offset>
This command defines the frequency offset.
User Manual 1175.7068.02 ─ 12
Remote Commands in Spectrum Analyzer Mode
Range: 1 to 100
*RST: 10
Default unit: PCT
FREQ:CENT:STEP:LINK:FACT 20PCT
See "0.1*Span (span > 0)"
See "0.1*RBW (span > 0)"
See "0.5*Span (span > 0)"
See "0.5*RBW (span > 0)"
CW
Selects the time domain (span = 0).
In the time domain, define the measurement frequency with
[SENSe:]FREQuency:CENTer.
FIXed
Selects the time domain (span = 0).
In the time domain, define the measurement frequency with
[SENSe:]FREQuency:CENTer.
SWEep
Selects the frequency domain (span > 0).
In the frequency domain, define the frequency characteristics
with the following commands:
•
[SENSe:]FREQuency:STARt
•
[SENSe:]FREQuency:STOP
•
[SENSe:]FREQuency:SPAN
•
[SENSe:]FREQuency:CENTer
*RST: SWEep
FREQ:MODE SWE
Selects the frequency domain.
SCPI confirmed
Remote Control
on page 345
on page 345
on page 346
on page 346
824