R&S ESR Series User Manual page 916

®
R&S ESR
Manual operation:
SYSTem:COMMunicate:GPIB:RDEVice:GENerator<generator>:ADDRess
Changes the IEC/IEEE-bus address of the external tracking generator.
This command is only available if the R&S FSV-B10 option (External Tracking Genera-
tor) is installed.
Suffix:
<generator>
Parameters:
<Number>
Example:
Mode:
SYSTem:COMMunicate:RDEVice:GENerator<generator>:INTerface <Type>
Defines the interface used for the connection to the external tracking generator.
This command is only available if the R&S FSV-B10 option (External Tracking Genera-
tor) is installed.
Suffix:
<generator>
Parameters:
<Type>
Example:
Mode:
Manual operation:
SYSTem:COMMunicate:RDEVice:GENerator<generator>:LINK <Type>
This command selects the link type of the external generator if the GPIB interface is
used.
User Manual 1175.7068.02 ─ 12
See "Source RF Internal (On/ Off)"
<Number>
.
1 | 2
tracking generator
For Noise Figure measurements (K30): 1 only
Range:
*RST:
SYST:COMM:GPIB:RDEV:GEN1:ADDR 15
A, NF
.
1 | 2
tracking generator
For Noise Figure measurements (K30): 1 only
GPIB | TCPip
*RST:
SYST:COMM:RDEV:GEN1:INT TCP
A, NF
See "Interface"
Remote Commands to Control the Tracking Generator
0 to 30
28
GPIB
on page 491
Remote Control
on page 477
913