R&S ESR Series User Manual page 558

®
R&S ESR
tions. Tables provide a fast overview of the bit assignment in the status registers. The
tables are supplemented by a comprehensive description of the status registers.
11.1.1.1 VISA Libraries
VISA is a standardized software interface library providing input and output functions to
communicate with instruments. The I/O channel (LAN or TCP/IP, USB, GPIB,...) is
selected at initialization time by means of the channel–specific address string ("VISA
resource string") indicated in
(short name). A VISA installation is a prerequisite for remote control using the VXI-11,
raw socket, RSIB or the newer HiSLIP protocol. The necessary VISA library is availa-
ble as a separate product. For details contact your local R&S sales representative.
For more information on VISA refer to the user documentation.
11.1.1.2 Messages
The messages transferred on the data lines are divided into the following categories:
●
Interface messages
Interface messages are transmitted to the instrument on the data lines, with the
attention line being active (LOW). They are used to communicate between the con-
troller and the instrument. Interface messages can only be sent by instruments that
have GPIB bus functionality. For details see the sections for the required interface.
●
Instrument messages
Instrument messages are employed in the same way for all interfaces, if not indica-
ted otherwise in the description. Structure and syntax of the instrument messages
are described in
detailed description of all messages available for the instrument is provided in the
chapter "Remote Control Commands".
There are different types of instrument messages, depending on the direction they
are sent:
–
–
Commands
Commands (program messages) are messages the controller sends to the instrument.
They operate the instrument functions and request information. The commands are
subdivided according to two criteria:
●
According to the effect they have on the instrument:
–
–
●
According to their definition in standards:
User Manual 1175.7068.02 ─ 12
Table
Chapter 11.1.4, "SCPI Command
Commands
Instrument responses
Setting commands cause instrument settings such as a reset of the instru-
ment or setting the frequency.
Queries cause data to be provided for remote control, e.g. for identification of
the instrument or polling a parameter value. Queries are formed by directly
appending a question mark to the command header.
11-1, or by an appropriately defined VISA alias
Structure",
Remote Control
Remote Control - Basics
on page 564. A
555