R&S ESR Series User Manual page 843

®
R&S ESR
Example:
Manual operation:
TRIGger<n>[:SEQuence]:TIME:RINTerval <Interval>
This command sets the repetition interval for the time trigger source.
Suffix:
<n>
Parameters:
<Interval>
Example:
Mode:
Manual operation:
Gated Measurements
[SENSe:]SWEep:EGATe
[SENSe:]SWEep:EGATe:HOLDoff
[SENSe:]SWEep:EGATe:LENGth
User Manual 1175.7068.02 ─ 12
Remote Commands in Spectrum Analyzer Mode
MASK
Selects the frequency mask trigger.
TDTRigger
Selects the time domain trigger.
TIME
Selects the time trigger.
VIDeo
Selects the video trigger. The video trigger is available for time
domain measurements.
*RST: IMMediate
TRIG:SOUR EXT
Selects the external trigger input as source of the trigger signal
See "External" on page 186
See "Free Run" on page 186
See "Video" on page 186
See "Trg/Gate Source"
See "Free Run" on page 375
See "External" on page 375
See "Video" on page 376
See "RF Power" on page 376
See "IF Power/BB Power"
See "Time" on page 377
.
irrelevant
2.0 ms to 5000
*RST: 1.0
TRIG:SOUR TIME
Selects the time trigger input for triggering.
TRIG:TIME:RINT 50
The sweep starts every 50 s.
All
See "Repetition Interval"
................................................................................................. 841
....................................................................................841
.....................................................................................842
on page 375
on page 376
on page 378
Remote Control
840