R&S ESR Series User Manual page 584

®
R&S ESR
Table 11-8: Meaning of the bits used in the STATus:OPERation register
Bit No.
0
1 to 7
8
9
10
11
12
13 to 14
15
STATus:QUEStionable Register
The STATus:QUEStionable register contains information about states that may occur if
the R&S ESR is operated without meeting the specifications.
You can read out the state of the register with
and STATus:QUEStionable[:EVENt]?.
Table 11-9: Meaning of the bits used in the STATus:QUEStionable register
Bit No.
0 - 2
3
4
5
6 - 7
8
9
User Manual 1175.7068.02 ─ 12
Meaning
CALibrating
This bit is set as long as the instrument is performing a calibration.
Not used
HardCOPy in progress
This bit is set while the instrument is printing a hardcopy.
SCAN results available
This bit is set when a block of scan results is available.
Note that this function must be enabled by TRACe:FEED:CONTol ALWays.
Sweep Break
This bit is set when the end of a scan range is reached.
To proceed, you have to use the INITiate:CONMeas command.
Not used
Threshold signal active
Not used
This bit is always 0.
Meaning
These bits are not used
POWer
This bit is set if a questionable power occurs (see
on page 584).
TEMPerature
This bit is set if a questionable temperature occurs.
FREQuency
The bit is set if a frequency is questionable (see
on page 582).
Not used
CALibration
The bit is set if a measurement is performed unaligned ("UNCAL" display)
LIMit (device-specific)
This bit is set if a limit value is violated (see
on page 582)
Remote Control - Basics
STATus:QUEStionable:CONDition?
"STATus:QUEStionable:POWer Register"
"STATus:QUEStionable:FREQuency Register"
"STATus:QUEStionable:LIMit Register"
Remote Control
581