R&S ESR Series User Manual page 646

®
R&S ESR
Example:
Manual operation:
[SENSe:]FMEasurement:AUTO <State>
This command turns automatic final measurements on and off.
Parameters:
<State>
Example:
Manual operation:
[SENSe:]FMEasurement:TIME <Time>
This command defines the time each frequency in the peak list is measured during the
final measurement.
Parameters:
<Time>
Example:
11.4.1.5 Trace Data and Result Query
This section contains information on the TRACe:DATA command and a detailed
description of the characteristics of that command. Basically, the command queries the
results of the current measurement. The command supports various SCPI parameters
in combination with the query. Each SCPI parameter returns a different aspect of the
measurement.
The format of the return values is either in ASCII or binary characters and depends on
the format you have set with
Querying trace data
The SCPI parameters TRACE1 | ... | TRACE6 return the trace data for the correspond-
ing trace.
User Manual 1175.7068.02 ─ 12
*RST: QPEak
DET:FME POS
See "Trace 1 to 6" on page 196
See "Trace 1 - 6" on page 199
ON
Turns on automatic final measurement.
OFF
Turns on interactive final measurement.
*RST: ON
FME:AUTO ON
See "Automatic Final"
See "Interactive Final"
See "Interactive Mode"
*RST: 1 s
FME:TIME 1us
Defines a measurement time of 1 µs.
FORMat[:DATA]
Remote Commands in Receiver Mode
on page 161
on page 161
on page 196
on page 850.
Remote Control
643