R&S ESR Series User Manual page 739

®
R&S ESR
Suffix:
<channel>
Parameters:
<State>
Example:
Manual operation:
[SENSe:]POWer:ACHannel:FILTer[:STATe]:ALL <State>
This command activates the weighting filter for all channels.
Parameters:
<State>
Example:
Selecting the Reference Channel
The following commands define the reference channel for relative ACLR measure-
ments.
[SENSe:]POWer:ACHannel:REFerence:AUTO ONCE
[SENSe:]POWer:ACHannel:REFerence:TXCHannel:AUTO
[SENSe:]POWer:ACHannel:REFerence:TXCHannel:MANual
[SENSe:]POWer:ACHannel:REFerence:AUTO ONCE
This command sets the reference value to the currently measured channel power for
the relative measurement.
Example:
Manual operation:
[SENSe:]POWer:ACHannel:REFerence:TXCHannel:AUTO <Channel>
This command activates the automatic selection of a transmission channel to be used
as a reference channel in relative adjacent-channel power measurements.
The transmission channel with the highest power, the transmission channel with the
lowest power, or the transmission channel nearest to the adjacent channels can be
defined as a reference channel.
User Manual 1175.7068.02 ─ 12
Remote Commands in Spectrum Analyzer Mode
.
1...18
the TX channel
ON | OFF
*RST: OFF
POW:ACH:FILT:CHA3 ON
Activates the weighting filter for TX channel 3.
See "Weighting Filter"
ON | OFF
*RST: OFF
POW:ACH:FILT ON
POW:ACH:REF:AUTO ONCE
See "Set CP Reference"
on page 240
....................................................... 736
................................................ 736
............................................. 737
on page 244
Remote Control
736