R&S ESR Series User Manual page 841

®
R&S ESR
Suffix:
<n>
Parameters:
<TriggerLevel>
Example:
TRIGger<n>[:SEQuence]:LEVel:IFPower <TriggerLevel>
This command defines the power level at the third intermediate frequency that must be
exceeded to cause a trigger event. Note that any RF attenuation or preamplification is
considered when the trigger level is analyzed. If defined, a reference level offset is also
considered.
Suffix:
<n>
Parameters:
<TriggerLevel>
Example:
Manual operation:
TRIGger<n>[:SEQuence]:LEVel:RFPower <TriggerLevel>
This command defines the power level at the third intermediate frequency that must be
exceeded to cause a trigger event. Note that any RF attenuation or preamplification is
considered when the trigger level is analyzed. If defined, a reference level offset is also
considered.
Suffix:
<n>
Parameters:
<TriggerLevel>
Example:
TRIGger<n>[:SEQuence]:LEVel:VIDeo <Value>
This command sets the level of the video trigger source.
Suffix:
<n>
Parameters:
<Value>
Example:
User Manual 1175.7068.02 ─ 12
Remote Commands in Spectrum Analyzer Mode
.
irrelevant
Range: 0.5 V to 3.5 V
*RST: 1.4 V
TRIG:LEV 2V
.
irrelevant
*RST: -20 dBm
TRIG:LEV:IFP -30DBM
See "Trg/Gate Level" on page 377
See "Trigger Level" on page 472
.
irrelevant
*RST: -20 dBm
TRIG:LEV:RFP -30dBm
.
irrelevant
0 to 100 PCT
*RST: 50 PCT
TRIG:LEV:VID 50PCT
Remote Control
838