R&S ESR Series User Manual page 196

®
R&S ESR
Remote command:
CALCulate<n>:PEAKsearch|PSEarch:METHod
No Of Peaks
Defines the number of peaks the R&S ESR looks for during a peak search.
The range is from 1 to 500 peaks.
The number of peaks only takes effect if the peak search mode is "Peaks".
Remote command:
CALCulate<n>:PEAKsearch|PSEarch:SUBRanges
No of Subranges / Peaks per Subrange
Defines the number of subranges for a subrange peak search and the number of
peaks that the R&S ESR looks for in each subrange.
Note that the maximum number of peaks is 500. Thus, the maximum number of peaks
per subrange depends on the number of subranges you have defined.
These parameters only take effect if the peak search mode is "Subranges".
Remote command:
Number of subranges:
CALCulate<n>:PEAKsearch|PSEarch:SUBRanges
Peaks per subrange:
CALCulate<n>:PEAKsearch|PSEarch:SUBRanges:PCOunt
Peak Excursion
Defines the relative signal level to determine a peak during a peak search.
For more information see
Remote command:
CALCulate<n>:MARKer<m>:PEXCursion
Margin
Defines an additional level margin relative to a limit line that is considered during a
peak search.
For more information see
Remote command:
CALCulate<n>:PEAKsearch|PSEarch:MARGin
Select Limit Line
Applies one or more limit lines for the peak search.
For more information on limit lines see
"Assign to
Trace"
"Deselect all
Traces"
"Limitcheck
(On Off)"
User Manual 1175.7068.02 ─ 12
Chapter 5.1.4, "Peak List and Data
Chapter 5.1.4, "Peak List and Data
Chapter 5.4.3, "(Limit)
Assigns the limit line to one or more traces.
Turns the limit check on and off.
Common Measurement Settings
on page 680
on page 680
on page 680
on page 681
Reduction",
on page 679
Reduction",
on page 680
Lines",
Receiver Mode
on page 148.
on page 148.
on page 208.
193