R&S ESR Series User Manual page 775

®
R&S ESR
[SENSe:]ESPectrum:FILTer[:RRC][:STATe] <State>
This command activates or deactivates the use of an RRC filter. This setting only takes
effect if channel power is selected as power reference type (see
]ESPectrum:RTYPe
Parameters:
<State>
Example:
Manual operation:
[SENSe:]ESPectrum:RRANge
This command returns the current position (number) of the reference range.
Example:
[SENSe:]ESPectrum:RTYPe <Type>
This command sets the power reference type.
Parameters:
<Type>
Example:
Manual operation:
Configuring Power Classes
The following commands define the power classes for SEM measurements.
CALCulate<n>:LIMit<k>:ESPectrum:LIMits
CALCulate<n>:LIMit<k>:ESPectrum:MODE
CALCulate<n>:LIMit<k>:ESPectrum:PCLass<Class>:COUNt
CALCulate<n>:LIMit<k>:ESPectrum:PCLass<Class>[:EXCLusive]
CALCulate<n>:LIMit<k>:ESPectrum:PCLass<Class>:LIMit[:STATe]
User Manual 1175.7068.02 ─ 12
Remote Commands in Spectrum Analyzer Mode
on page 772).
ON | OFF
*RST: ON
ESP:RTYP CPOW
Sets the power reference type to channel power.
ESP:FILT OFF
Deactivates the use of an RRC filter.
See "Edit Reference Range"
ESP:RRAN?
Returns the current position (number) of the reference range.
PEAK | CPOWer
PEAK
Measures the highest peak within the reference range.
CPOWer
Measures the channel power within the reference range (integral
bandwidth method).
*RST: CPOWer
ESP:RTYP PEAK
Sets the peak power reference type.
See "Edit Reference Range"
.......................................................................773
......................................................................773
Remote Control
[SENSe:
on page 263
on page 263
............................................. 774
......................................774
.................................... 774
772