R&S ESR Series User Manual page 860

®
R&S ESR
Example:
Manual operation:
CALCulate<n>:SGRam:CONT <State>
This command determines whether the results of the last measurement are deleted
before starting a new measurement in single sweep mode.
Suffix:
<n>
Parameters:
<State>
Example:
Manual operation:
CALCulate<n>:SGRam:FRAMe:COUNt <Frames>
This command sets the number of frames to be recorded in a single sweep.
Suffix:
<n>
Parameters:
<Frames>
Example:
Manual operation:
User Manual 1175.7068.02 ─ 12
Remote Commands in Spectrum Analyzer Mode
CALC:SGR:COL GRAY
Selects black and white color scheme.
See "Color Mapping" on page 406
.
1...4
Selects the measurement window.
ON | OFF
*RST: OFF
INIT:CONT OFF
Selects single sweep mode.
INIT;*WAI
Starts the sweep and waits for the end of the sweep.
CALC:SGR:CONT ON
Repeats the single sweep measurement without deleting the
results of the last measurement.
See "Continue Frame (On Off)"
.
1...4
Selects the measurement window.
The maximum number of frames depends on
the .CALCulate<n>:SGRam:HDEPth
Range: 1 to depends on history depth
Increment: 1
*RST: 1
INIT:CONT OFF
Selects single sweep mode.
CALC:SGR:FRAM:COUN 200
Sets the number of frames to 200.
See "Frame Count" on page 373
Remote Control
on page 373
on page 651
857