Rear Panel View - R&S ESR Series User Manual

®
R&S ESR
The output of the tracking generator is connected to the DUT via a cable equipped with
a male N connector. The female connector is available only with the tracking generator
option (R&S FSV-B9).
Risk of damaging the tracking generator
To avoid damaging the tracking generator, make sure that the reverse power (i.e. input
power caused, for example, by reflections in the test setup) never exceeds 1 W RF
power. Do not apply a DC voltage at the output.
For details, refer to the data sheet.
Sensitive DUTs concerning matching
For DUTs with sensitive RF characteristics with regard to matching (VSWR) at the
input, insert a 10 dB attenuator between the DUT and the tracking generator.

3.1.2 Rear Panel View

The rear panel of the R&S ESR is shown in
more detail in the subsequent sections.
Figure 3-3: R&S ESR rear panel
1 = LAN
2 = TRIGGER OUTPUT
3 = IF/VIDEO
4 = USB
5 = AUX PORT
6 = EXT TRIGGER / GATE IN
7 = MONITOR (VGA)
8 = REF IN
User Manual 1175.7068.02 ─ 12
Front and Rear Panel View
Figure 3-3. Each element is described in
Quick Start
35