R&S ESR Series User Manual page 760

®
R&S ESR
[SENSe:]LIST:RANGe<range>:SWEep:TIME
This command sets the sweep time for the specified range.
Suffix:
<range>
Parameters:
<SweepTime>
Example:
Manual operation:
[SENSe:]LIST:RANGe<range>:SWEep:TIME:AUTO
This command activates or deactivates the automatic sweep time setting for the speci-
fied range.
Suffix:
<range>
Parameters:
<State>
Example:
Manual operation:
[SENSe:]LIST:RANGe<range>:TRANsducer <TransducerName>
This command sets a transducer for the specified range. You can only choose a trans-
ducer that fulfills the following conditions:
●
The transducer overlaps or equals the span of the range.
●
The x-axis is linear.
●
The unit is dB.
Suffix:
<range>
Parameters:
<TransducerName>
Example:
User Manual 1175.7068.02 ─ 12
Remote Commands in Spectrum Analyzer Mode
.
1...20
range
Allowed values depend on the ratio of span to RBW and RBW to
VBW. For details refer to the data sheet.
*RST: 0.27 s
LIST:RANG1:SWE:TIME 1
Sets the sweep time for range 1 to 1 s.
See "Sweep Time" on page 290
.
1...20
range
ON | OFF
*RST: ON
LIST:RANG3:SWE:TIME:AUTO OFF
Deactivates the sweep time auto mode for range 3.
See "Sweep Time Mode"
.
1...20
range
'string' = name of the transducer
SENS:LIST:RANG1:TRAN 'test'
Sets the transducer called "test" for range 1.
Remote Control
on page 290
757