R&S ESR Series User Manual page 716

®
R&S ESR
Example:
Manual operation:
CALCulate<n>:LIMit<k>:LOWer:SHIFt <Distance>
This command moves a complete lower limit line vertically.
Compared to defining an offset, this command actually changes the limit line definition
points by the value you define.
Suffix:
<n>
<k>
Parameters:
<Distance>
Example:
CALCulate<n>:LIMit<k>:LOWer:SPACing <InterpolType>
This command selects linear or logarithmic interpolation for the lower limit line.
Suffix:
<n>
<k>
Parameters:
<InterpolType>
Example:
CALCulate<n>:LIMit<k>:LOWer:STATe <State>
This command turns a lower limit line on and off.
Before you can use this command, you have to select a limit line with
CALCulate<n>:LIMit<k>:NAME.
The limit check is turned on separately. For more information see
Lines"
Suffix:
<n>
User Manual 1175.7068.02 ─ 12
CALC:LIM2:LOW:OFFS 3dB
Shifts limit line 2 by 3 dB upwards.
See "Y Offset"
.
irrelevant
Selects the limit line.
Numeric value that defines the distance of the shift.
The unit depends on
on page 708.
CALC:LIM3:LOW:SHIF 20DB
Shifts all Y values of limit line 3 by 20 dB.
.
irrelevant
1...8
Selects the limit line.
LINear | LOGarithmic
*RST:
CALC:LIM:LOW:SPAC LIN
on page 860.
.
irrelevant
Remote Commands in Receiver Mode
on page 212
CALCulate<n>:LIMit<k>:UNIT
LIN
Remote Control
"Using Frequency
713