R&S ESR Series User Manual page 955

®
R&S ESR
Example:
Manual operation:
[SENSe:]CORRection:TRANsducer:DATA <Frequency>,<Level>
This command defines the shape of the transducer factor.
A transducer factor may contain up to 625 reference values. Each reference value is a
combination of a frequency and a level value.
Before you can use this command, you have to select a transducer factor with
[SENSe:]CORRection:TRANsducer:SELect
Parameters:
<Frequency>
<Level>
Example:
Manual operation:
[SENSe:]CORRection:TRANsducer:DELete
This command deletes a transducer factor.
Before you can use the command, you have to select a transducer factor with
[SENSe:]CORRection:TRANsducer:SELect.
Example:
Usage:
Manual operation:
[SENSe:]CORRection:TRANsducer:SCALing <Scale>
This command selects the scale of the transducer factor.
Before you can use the command, you have to select a transducer factor with
[SENSe:]CORRection:TRANsducer:SELect
Parameters:
<Scale>
Example:
User Manual 1175.7068.02 ─ 12
See "Designing a transducer factor"
See "Defining characteristics of a transducer factor"
on page 508
Numeric value in Hz.
The frequency values have to be in ascending order.
The unit depends on
[SENSe:]CORRection:TRANsducer:
on page 953. By default, it is dB.
UNIT
See "Designing a transducer factor"
See "Defining characteristics of a transducer factor"
on page 508
CORR:TRAN:SEL 'Transducer 1'
CORR:TRAN:DEL
Deletes the selected transducer.
Event
See "Defining characteristics of a transducer factor"
on page 508
LINear | LOGarithmic
*RST: LINear
See "Designing a transducer factor"
Remote Control
Using Transducers
on page 949.
on page 953.
on page 949.
on page 953R&S ESR.
on page 949.
952