R&S ESR Series User Manual page 934

®
R&S ESR
11.9.4 Controlling In- and Ouputs
DIAGnostic<n>:SERVice:NSOurce
INPut:PRESelection:STATe
INPut<ip>:UPORt:STATe
INPut<ip>:UPORt[:VALue]
OUTPut:IF[:SOURce]
OUTPut:TRIGger
OUTPut:UPORt:STATe
OUTPut:UPORt[:VALue]
DIAGnostic<n>:SERVice:NSOurce <State>
This command switches the 28 V supply of the noise source on the front panel on or
off.
Suffix:
<n>
Parameters:
<State>
Example:
Manual operation:
INPut:PRESelection:STATe <State>
This command turns the preselector on and off.
Parameters:
<State>
Example:
Manual operation:
INPut<ip>:UPORt:STATe <State>
This command toggles the control lines of the user ports for the AUX PORT connector.
This 9-pole SUB-D male connector is located on the rear panel of the R&S ESR.
See the R&S ESR Getting Started manual for details.
Suffix:
<ip>
Parameters:
<State>
User Manual 1175.7068.02 ─ 12
.................................................................................. 931
............................................................................................. 931
.................................................................................................931
...............................................................................................932
..................................................................................................... 932
........................................................................................................... 932
................................................................................................... 933
................................................................................................. 933
.
irrelevant
ON | OFF
*RST: OFF
DIAG:SERV:NSO ON
See "Noise Source"
ON | OFF
*RST: ON
INP:PRES:STAT OFF
Turns off the preselector.
See "Preselector (On Off)"
.
1 | 2
irrelevant
System Configuration
on page 384
on page 384
Remote Control
931