R&S ESR Series User Manual page 905

®
R&S ESR
Example:
Usage:
Manual operation:
[SENSe:]CORRection:METHod <Type>
This command selects the type of measurement to be performed with the tracking gen-
erator.
The command is available if a tracking generator is installed and has been turned on.
Parameters:
<Type>
Example:
Manual operation:
[SENSe:]CORRection:RECall
This command restores the measurement configuration used for calibration.
The command is available if a tracking generator is installed and has been turned on.
Example:
Usage:
Manual operation:
[SENSe:]CORRection[:STATe] <State>
This command turns correction of measurement results (normalization) on and off.
The command is available after you have defined a reference trace for the selected
measurement type with
User Manual 1175.7068.02 ─ 12
Remote Commands to Control the Tracking Generator
INIT:CONT OFF
Selects single sweep operation
CORR:COLL THR;*WAI
Starts the measurement of reference data using direct connec-
tion between generator and device input and waits for the sweep
end.
Setting only
SCPI confirmed
See "Calibrate Reflection Short"
See "Calibrate Reflection Open"
REFLection
Selects reflection measurements.
TRANsmission
Selects transmission measurements.
*RST: TRANsmission
CORR:METH TRAN
Sets the type of measurement to "transmission".
See "Calibrate Transmission"
See "Calibrate Reflection Short"
See "Calibrate Reflection Open"
CORR:REC
Event
SCPI confirmed
See "Recall" on page 478
[SENSe:]CORRection:COLLect[:ACQuire]
Remote Control
on page 477
on page 477
on page 477
on page 477
on page 477
on page 901.
902