R&S ESR Series User Manual page 687

®
R&S ESR
Example:
Manual operation:
11.4.6.6 LISN Settings
[SENSe:]FMEasurement:LISN:FILTer:HPAS[:STATe]
[SENSe:]FMEasurement:LISN:PHASe
[SENSe:]FMEasurement:LISN[:TYPE]
INPut:LISN:FILTer:HPAS[:STATe]
INPut:LISN:PHASe
INPut:LISN[:TYPE]
[SENSe:]FMEasurement:LISN:FILTer:HPAS[:STATe] <State>
This command turns the 150 kHz highpass filter of the ENV216 network for the final
measurement on and off.
The command is available for the R&S ENV216 network.
Parameters:
<State>
Example:
Manual operation:
[SENSe:]FMEasurement:LISN:PHASe <Phase>, [<Phase>]
This command selects the phase of the network used for the final measurement.
Parameters:
<Phase>
User Manual 1175.7068.02 ─ 12
WRITe
Clear write trace mode.
INIT:CONT OFF
Switching to single sweep mode.
SWE:COUN 16
Sets the number of measurements to 16.
DISP:TRAC3:MODE MAXH
Switches on the calculation of the maximum peak for trace 3.
INIT;*WAI
Starts the measurement and waits for the end of the 16 sweeps.
See "Clear Write"
See "Max Hold" on page 171
See "Min Hold" on page 172
See "View" on page 172
See "Trace 1 to 6"
See "Trace 1 - 6"
See "Average" on page 390
............................................................................. 684
..............................................................................685
.....................................................................................685
.........................................................................................................686
.........................................................................................................686
ON | OFF
*RST: ON
FME:LISN:FILT:HPAS ON
Turns on the highpass filter.
See "150 kHz Highpass Filter"
L1
Remote Commands in Receiver Mode
on page 171
on page 196
on page 199
......................................................... 684
on page 198
Remote Control
684