R&S ESR Series User Manual page 923

®
R&S ESR
SYSTem:SPEaker:VOLume
SYSTem:TIME
SYSTem:TIME:TSTamp?
SYSTem:VERSion?
SYSTem:DISPlay:FPANel
SYSTem:DEVice:ID?
SYSTem:DATE
SYSTem:APPLication:SRECovery[:STATe] <State>
Controls instrument behavior when switching between measurement applications, e.g.
from "Spectrum" to "Analog Demod" and back.
If activated, the current instrument settings are stored when you switch to a different
application. When you switch back to the previous application, the corresponding
instrument settings are restored. Thus, the settings of the individual applications are
independant of each other.
If deactivated (default), only a few parameters of the current instrument setting are
passed between applications (e.g. center frequency, level settings).
Note that although the default value is "OFF", this parameter is not reset using the
[PRESET] key. Thus it must be deactivated manually, if necessary.
Parameters:
<State>
Example:
Manual operation:
SYSTem:CLOGging <State>
This command turns logging of remote commands on and off.
Parameters:
<State>
Manual operation:
SYSTem:COMPatible <Mode>
Sets the device in a state compatible to previous R&S signal analyzers, e.g. regarding
the number of sweep points.
Parameters:
<Mode>
User Manual 1175.7068.02 ─ 12
............................................................................................ 923
............................................................................................................... 923
................................................................................................ 923
........................................................................................................923
............................................................................................... 924
...................................................................................................... 924
.............................................................................................................. 924
ON | OFF
*RST: OFF (not restored using the "PRESET" function)
SYST:APPL:SREC ON
See "Application Setup Recovery"
ON
Writes all remote commands that have been sent to a file.
The destination is C:
\R_S\instr\ScpiLogging\ScpiLog.txt.
OFF
*RST: OFF
See "I/O Logging (On/Off)"
DEFault | FSU | FSP
Remote Control
System Configuration
on page 526
on page 518
920