R&S ESR Series User Manual page 783

®
R&S ESR
Manual operation:
CALCulate<n>:MARKer<m>:FUNCtion:FMEasurement:DETector <Detector>
This command selects the detector for a specific marker during the final measurement.
If the marker hasn't been active yet, the command also turns the marker on.
Suffix:
<n>
<m>
Parameters:
<Detector>
Manual operation:
CALCulate<n>:MARKer<m>:FUNCtion:FMEasurement:DWELl <Time>
This command defines the dwell time during the final measurement.
Suffix:
<n>
<m>
Parameters:
<Time>
Manual operation:
User Manual 1175.7068.02 ─ 12
Remote Commands in Spectrum Analyzer Mode
POS
maximum peak detector
QPE
quasipeak detector
*RST: OFF
See "Marker Configuration"
.
irrelevant
marker
OFF
turns the marker off
AVER
average detector
CAV
CISPR Average detector
CRMS
RMS Average detector
POS
maximum peak detector
QPE
quasipeak detector
*RST: OFF
See "Marker Configuration"
.
irrelevant
irrelevant
Range: min value to max value
*RST: 1 s
Default unit: seconds
See "Marker Configuration"
See "Dwell Time" on page 305
Remote Control
on page 303
on page 303
on page 303
780