R&S ESR Series User Manual page 770

®
R&S ESR
Example:
Manual operation:
[SENSe:]ESPectrum:RANGe<range>:INSert <Mode>
This command inserts a new range before or after the specified range. The range num-
bers are updated accordingly.
Suffix:
<range>
Parameters:
<Mode>
Example:
Manual operation:
[SENSe:]ESPectrum:RANGe<range>:LIMit<source>:ABSolute:STARt <Level>
This command sets an absolute limit value at the start frequency of the specified
range. Different from manual operation, this setting is independently of the defined limit
check type.
Suffix:
<range>
Parameters:
<Level>
Example:
Manual operation:
[SENSe:]ESPectrum:RANGe<range>:LIMit<source>:ABSolute:STOP <Level>
This command sets an absolute limit value at the stop frequency of the specified
range. Different from manual operation, this setting is independent of the defined limit
check type.
User Manual 1175.7068.02 ─ 12
Remote Commands in Spectrum Analyzer Mode
ESP:RANG3:INP:GAIN:STATe ON
Switches the preamplifier for range 3 on or off.
See "Preamp" on page 260
.
1...20
range
AFTer | BEFore
ESP:RANG3:INS BEF
Inserts a new range before range 3.
ESP:RANG1:INS AFT
Inserts a new range after range 1.
See "Insert before Range"
See "Insert after Range"
.
1...20
range
-400 to in 400 dBm
*RST: 13 dBm
ESP:RANG1:LIM:ABS:STAR 10
Sets an absolute limit of 10 dBm at the start frequency of the
range.
See "Abs Limit Start" on page 261
Remote Control
on page 262
on page 262
767