R&S ESR Series User Manual page 641

®
R&S ESR
DISPlay:BARGraph:PHOLd:RESet
DISPlay:BARGraph:TCOupling[:STATe]
[SENSe:]DETector:RECeiver[:FUNCtion]
[SENSe:]SWEep:TIME
DISPlay:BARGraph:LEVel:LOWer?
This command queries the minimum level of the bargraph.
Example:
Usage:
DISPlay:BARGraph:LEVel:UPPer?
This command queries the maximum level of the bargraph.
Example:
Usage:
DISPlay:BARGraph:PHOLd[:STATe] <State>
This command switches the indication of the maxhold value of the bar graph measure-
ment on or off.
Parameters:
<State>
Example:
Manual operation:
DISPlay:BARGraph:PHOLd:RESet
This command resets the maxhold value of the numeric indication of the bargraph
measurement.
Example:
Usage:
Manual operation:
DISPlay:BARGraph:TCOupling[:STATe] <State>
This command couples or decouples the bargraph detector and scan trace detector.
Parameters:
<State>
User Manual 1175.7068.02 ─ 12
.................................................................................. 638
............................................................................638
.......................................................................... 639
................................................................................................... 639
:DISP:BARG:LEV:LOW?
Query only
:DISP:BARG:LEV:UPP?
Query only
ON
OFF
*RST: OFF
DISP:BARG:PHOL ON
See "Bargraph Maxhold"
:DISP:BARG:PHOL:RES
Event
See "Maxhold Reset"
ON | OFF
*RST: OFF
Remote Commands in Receiver Mode
on page 158
on page 158
Remote Control
638