Analysis; Trace Configuration - R&S ESR Series User Manual

®
R&S ESR
State
Activates a connected probe. Use this command to switch off the probe and measure
the digital input without considering the transducer factor of the probe.
Remote command:
PROBe[:STATe]
Name
Indicates the name of the connected probe.
Remote command:
PROBe:SETup:NAME?
Serial Number
Indicates the serial number of the connected probe.
Remote command:
PROBe:ID:SRNumber?
Part number
Indicates the material part number of the connected probe.
Remote command:
PROBe:ID:PARTnumber?
Micro Button Action
Defines which action is taken when the probe's micro button is pressed.
"RunSingle"
"No Action"
Remote command:
PROBe:SETup:MODE

6.3 Analysis

General methods and basic settings to display and analyze measurements. If you are
performing a specific measurement task or using an operating mode other than Spec-
trum mode, be sure to check the specific measurement or mode description for set-
tings and functions that may deviate from these general ones.
● Trace
● Spectrogram..........................................................................................................402
● Markers................................................................................................................. 406
● Lines......................................................................................................................429

6.3.1 Trace Configuration

The TRACE key is used to configure the data acquisition for measurement and the
analysis of the measurement data.
User Manual 1175.7068.02 ─ 12
on page 822
on page 821
on page 821
on page 821
A single sweep is performed.
No action is taken.
on page 821
Configuration...............................................................................................387
Spectrum Measurements
Analysis
387