R&S ESR Series User Manual page 902

Emi test receiver

Table of Contents

To switch trace display back on, use the

Note: to enable the evaluation functions of the IQ Analyzer, you must also execute the

command TRACe<n>:IQ:EVAL.

Manual operation:

TRACe<n>:IQ:TPISample?

This command determines the time offset of the trigger in the sample (trigger position

in sample = TPIS). This value can only be determined in triggered measurements

using external or IFPower triggers, otherwise the value is 0. The value is not user-

Manual operation:

11.6.2 I/Q Gating

Sometimes in spectrum analysis, measurements are based on a certain length of time

called the gate area. With I/Q gating, you can define the gate area using the gate

length, the distance between the periods and the number of periods. The gate length

and the distance between the capture periods are specified in samples.

I/Q gating is only available using remote commands; manual configuration is not possi-

Using I/Q gating, the gate area can be defined using the following methods:

Edge triggered recording

After a trigger signal, the gate period is defined by a gate length and a gate dis-

tance. All data in the gate period is recorded until the required number of samples

has been recorded.

User Manual 1175.7068.02 ─ 12

Remote Commands in I/Q Analyzer Mode

TRACe<n>:IQ:EVAL

Switches on I/Q data acquisition

"I/Q Analyzer"

TRAC:IQ:TPIS?

"Trigger Offset"

Remote Control

Show Quick Links

Table of Contents