Measurement Settings - R&S ESR Series User Manual

®
R&S ESR
Skip Frequency
Skips the peak list entry the final measurement is due to measure next and proceeds
with the next peak.
Available for interactive final measurements.
Remote command:
-
Get Maxhold
Uses the highest level that was measured during the scan for the final results instead
of the signal level measured during the final measurement.
Remote command:
-
Measure
Initiates a final measurement on the current peak.
Available for interactive final measurements.
Remote command:
-
Stop Final Measurement
Aborts the final measurement.
Data that has already been collected is lost.
Remote command:
ABORt
5.1.7.6

Measurement Settings

The "Meas" menu contains the basic measurement settings and the selection of result
displays
► Press the [MEAS] key.
The R&S ESR opens the "Measurement" menu.
Receiver
Bargraph
Measurement
Demod.........................................................................................................................163
Add To Peak
Test
Receiver Frequency
Defines the receiver frequency.
User Manual 1175.7068.02 ─ 12
on page 640
(Chapter 5.1.7.2, "Selecting the Result
Frequency.................................................................................................... 162
Detector.......................................................................................................163
└ Couple to Scan Trace................................................................................... 163
Time..................................................................................................... 163
└ Demod (On Off)............................................................................................ 163
└ AM / FM........................................................................................................ 163
└ Squelch......................................................................................................... 164
List......................................................................................................... 164
Automation.......................................................................................................... 164
Receiver Mode
Measurements and Result Displays
Display", on page 156).
162