Specifying The Trace Settings; Description Of The Averaging Method - R&S ESR Series User Manual

®
R&S ESR
For details see
6.3.1.3

Specifying the Trace Settings

1. To configure one or more traces, see
on page 395.
2. To select the trace mode for the selected trace, press the softkey for the corre-
sponding trace (for details see
3. To select a detector, press the
or press the
on page 399).
4. To change the sweep count setting, which also determines trace averaging, press
the
5. To deactivate the reset of the traces in "Min Hold" and "Max Hold" mode after some
specific parameter changes, press the
6. To copy a trace into another trace memory, press the
Upon copying, the contents of the selected memory are overwritten and the new
contents are displayed in the View mode.
7. To export the active trace in ASCII format:
a) Press the "More" softkey.
b) If necessary, press the
c) Press the
6.3.1.4

Description of the Averaging Method

Averaging is carried out over the measurement points derived from the measurement
samples. Several measured values may be combined in a measurement point. This
User Manual 1175.7068.02 ─ 12
Preset All Traces
Select Max | Avg | Min
Select Max | ClrWrite | Min
Chapter 5.2.3, "Trace
Detector softkey (for details see
Sweep Count softkey.
with floating-point numerals.
ASCII File Export
The active trace is saved in ASCII format on the harddisk on or an external
storage device.
Trace 1: Clear Write
Trace 2-6: Blank
Trace 1: Max Hold
Trace 2: Average
Trace 3: Min Hold
Trace 4-6: Blank
Trace 1: Max Hold
Trace 2: Clear Write
Trace 3: Min Hold
Trace 4-6: Blank
Modes", on page 171.
Chapter 6.3.1.2, "Configuring
Chapter 5.2.3, "Trace
Auto Select softkey for automatic detector selection,
Chapter 6.3.1.5, "Detector
Trace Math
Decim Sep softkey to change the decimal separator
softkey to enter the ASCII file export name.
Spectrum Measurements
Traces",
Modes", on page 171).
Overview",
softkey.
Copy Trace softkey.
Analysis
397