R&S ESR Series User Manual page 828

®
R&S ESR
Parameters:
<Offset>
Example:
Manual operation:
[SENSe:]FREQuency:STARt <Frequency>
This command defines the start frequency for measurements in the frequency domain.
Parameters:
<Frequency>
Example:
Manual operation:
[SENSe:]FREQuency:STOP <Frequency>
This command defines the stop frequency for measurements in the frequency domain.
Parameters:
<Frequency>
Example:
Manual operation:
[SENSe:]FREQuency:SPAN <Span>
This command defines the frequency span.
Parameters:
<Span>
Example:
Manual operation:
[SENSe:]FREQuency:SPAN:FULL
This command sets the frequency span to its maximum.
Example:
Manual operation:
User Manual 1175.7068.02 ─ 12
Remote Commands in Spectrum Analyzer Mode
Range: -100 GHz to 100 GHz
*RST: 0 Hz
Default unit: Hz
FREQ:OFFS 1GHZ
See "Frequency Offset"
0 to (fmax - min span)
*RST: 0
FREQ:STAR 20MHz
See "Start" on page 347
min span to fmax
*RST: fmax
FREQ:STOP 2000 MHz
See "Stop" on page 347
*RST: fmax
FREQ:SPAN 10MHz
See "IF Span Manual"
See "Span Manual" on page 350
See "Zero Span" on page 350
FREQ:SPAN:FULL
See "Full Span" on page 180
on page 347
on page 180
Remote Control
825