R&S ESR Series User Manual page 643

®
R&S ESR
11.4.1.3 Scan Control
ABORt
HOLD
INITiate<n>:CONMeas
INITiate<n>:CONTinuous
INITiate<n>[:IMMediate]
ABORt
This command stops a measurement and resets the trigger system.
Example:
Usage:
Manual operation:
HOLD
This command interrupts a running scan measurement.
To resume the scan, use INITiate<n>[:IMMediate].
Example:
Manual operation:
INITiate<n>:CONMeas
This command resumes a scan that was interrupted by a transducer stop at the current
reciever frequency.
If the scan was interrupted by the
INITiate<n>[:IMMediate]
Example:
Usage:
User Manual 1175.7068.02 ─ 12
......................................................................................................................... 640
........................................................................................................................... 640
................................................................................................... 640
................................................................................................ 641
..................................................................................................641
ABOR;INIT:IMM
Aborts the measurement and restarts it.
SCPI confirmed
See "Stop Scan"
See "Stop Final Measurement"
See "Meas Start/Stop"
HOLD
Interrupts the scan.
See "Hold Scan"
See "Continue at Rec Frequency"
See "Hold Final Measurement"
INIT2:CONT OFF
Selects single scan mode.
SWE:COUN 20
Forms an average over 20 scans.
INIT2;*WAI
Starts the measurement and waits for the end of the 20 scans.
INIT2:CONM;*WAI
Continues the measurement (next 20 sequences) and waits for
the end.
Event
Remote Commands in Receiver Mode
on page 159
on page 162
on page 267
on page 159
on page 161
command, you have to resume it with
HOLD
on page 641.
Remote Control
on page 159
640