R&S ESR Series User Manual page 507

®
R&S ESR
For each user-definable softkey (1–8), you can define a key label and assign a settings
file that is to be loaded when the softkey is selected.
SCPI command:
MMEMory:USER<Softkey>
To define the key label
1. Click into the table entry for the corresponding softkey.
2. Enter a label for the softkey.
3. Press ENTER.
To assign a settings file
1. Click into the table entry for the corresponding softkey.
2. In the file selection dialog, select a stored settings file to be recalled when the soft-
key is selected.
3. Click "Select".
The selected file is displayed in the "ApplicationManager" dialog.
To store the softkey settings
► Click "Save" to store the user-defined softkey definitions.
9.3 Instrument Setup and Interface Configuration –
SETUP Key
The SETUP key is used to set or display the default settings of the instrument: refer-
ence frequency, noise source, level correction values, date, time, LAN interface, firm-
ware update and enabling of options, information about instrument configuration and
service support functions. For further details refer also to the Quick Start Guide, chap-
ter 2 "Preparing for Use".
To open the Setup menu
► Press the SETUP key.
The "Setup" menu is displayed.
Menu and softkey description
●
Chapter 9.3.1, "Softkeys of the Setup
User Manual 1175.7068.02 ─ 12
Instrument Setup and Interface Configuration – SETUP Key
on page 987
Menu",
System Configuration
on page 505
504