Softkeys Of The Trace Menu - R&S ESR Series User Manual

®
R&S ESR
The R&S ESR is capable of displaying up to six different traces at a time in a diagram.
A trace consists of a maximum of 691 displayed measurement points on the horizontal
axis (frequency or time). If more measured values than measurement points are availa-
ble, several measured values are combined in one displayed measurement point.
The trace functions include the following:
●
Display mode of the trace
For details on trace modes see
●
Evaluation of the trace as a whole
For details on averaging see
Method",
●
Evaluation of individual measurement points of a trace. For details on detectors
see
To open the Trace menu
●
Press the TRACE key.
The "Trace" menu is displayed. The "Trace Configuration" dialog box is displayed.
Menu and softkey description
●
Chapter 6.3.1.1, "Softkeys of the Trace
Further information
●
Chapter 5.2.3, "Trace
●
Chapter 6.3.1.5, "Detector
●
Chapter 6.3.1.6, "ASCII File Export
Tasks
●
Chapter 6.3.1.2, "Configuring
●
Chapter 6.3.1.3, "Specifying the Trace
6.3.1.1

Softkeys of the Trace Menu

The following table shows all softkeys available in the "Trace" menu. It is possible that
your instrument configuration does not provide all softkeys. If a softkey is only available
with a special option, model or (measurement) mode, this information is provided in the
corresponding softkey description.
Functions to configure traces described elsewhere:
●
"More Traces"
●
"Copy Trace"
●
"Trace Wizard"
●
"ASCII Trace Export"
●
"Decim Sep"
User Manual 1175.7068.02 ─ 12
on page 397.
Chapter 6.3.1.5, "Detector
Modes",
on page 199
on page 199
on page 199
on page 199
on page 200
Chapter 5.2.3, "Trace
Chapter 6.3.1.4, "Description of the Averaging
Overview", on page 399.
Menu", on page 388
on page 171
Overview", on page 399
Format", on page 399
Traces", on page 395
Settings", on page 397
Spectrum Measurements
Analysis
Modes", on page 171.
388