R&S ESR Series User Manual page 261

®
R&S ESR
Spectrum Emission Mask
Opens a submenu to configure the Spectrum Emission Mask measurement.
The Spectrum Emission Mask (SEM) measurement defines a measurement that moni-
tors compliance with a spectral mask. The SEM measurement of the base unit allows a
flexible definition of all parameters in the SEM measurement.
For general information on performing SEM measurements, see
"Measuring with Spectrum Emission
Remote command:
SENS:SWE:MODE ESP, see
Sweep List ← Spectrum Emission Mask
Opens a submenu to edit the sweep list and displays the "Sweep List" dialog box.
Sweep List dialog box ← Sweep List ← Spectrum Emission Mask
After a preset, the sweep list contains a set of default ranges and parameters. For
each range, you can change the parameters listed below. To insert or delete ranges,
use the "Insert Before Range", "Insert After Range", "Delete Range" softkeys. The
measurement results are not updated during editing but on closing the dialog box ("Edit
Sweep List/ Close Sweep List" softkey, see
User Manual 1175.7068.02 ─ 12
Masks", on page 256.
[SENSe:]SWEep:MODE
"Close Sweep List"
Spectrum Measurements
Measurements
Chapter 6.1.1.5,
on page 761
on page 262).
258