R&S ESR Series User Manual page 992

®
R&S ESR
MMEMory:NETWork:USEDdrives? <ResultType>
This command lists all mapped network drives.
Query parameters:
<ResultType>
Example:
Usage:
Manual operation:
SYSTem:COMMunicate:GPIB[:SELF]:ADDRess <Address>
This command changes the GPIB address of the unit.
Parameters:
<Address>
Example:
Usage:
Manual operation:
SYSTem:COMMunicate:GPIB[:SELF]:RTERminator <Terminator>
This command changes the GPIB receive terminator.
According to the standard the terminator in ASCII is <LF> and/or <EOI>. For binary
data transfers (e.g. trace data) from the control computer to the instrument, the binary
code (0AH) used for <LF> might be included in the binary data block, and therefore
should not be interpreted as a terminator in this particular case. This can be avoided by
changing the receive terminator to EOI.
Output of binary data from the instrument to the control computer does not require
such a terminator change.
Parameters:
<Terminator>
Example:
Manual operation:
User Manual 1175.7068.02 ─ 12
ON
Lists all mapped network drives including the folder information.
OFF
Lists all mapped network drive names.
*RST: OFF
MMEM:NETW:USED? ON
Lists all mapped network drives including the folder information.
Query only
See "Map Network Drive"
0 to 30
*RST: (no influence on this parameter, factory default 20)
SYST:COMM:GPIB:ADDR 18
SCPI confirmed
See "GPIB Address" on page 514
LFEOI | EOI
*RST: (no influence on this parameter, factory default
LFEOI)
SYST:COMM:GPIB:RTER EOI
See "GPIB Terminator LFEOI/EOI"
Remote Control
Network Connection
on page 536
on page 518
989