R&S ESR Series User Manual page 823

®
R&S ESR
<AVGPower>
<TriggerSource>
<TriggerSlope>
<TriggerOffset>
<GateLength>
Example:
[SENSe:]LIST:POWer:STATe <State>
This command turns the List Evaluation off.
Parameters:
<State>
Example:
11.5.1.15 Probe Configuration
PROBe:ID:PARTnumber?
PROBe:ID:SRNumber?
PROBe:SETup:MODE
PROBe:SETup:NAME?
PROBe:SETup:STATe?
PROBe[:STATe]
User Manual 1175.7068.02 ─ 12
ON | OFF
Turns average power evaluation on and off.
*RST: OFF
IMMediate | EXTernal | VIDeo | IFPower | RFPower
Selects a trigger source.
For more information see
*RST: IMM
NEGative | POSitive
Selects the trigger slope.
*RST: POS
Defines the trigger delay. The trigger delay is the time between
the detection of the trigger signal and the start of the measure-
ment at the next frequency point.
Range: span = 0 Hz: (-sweep time) to 30 s; span > 10 Hz:
31.25 ns to 30 s
*RST: 0 s
Defines the gate length for gated measurements.
Setting 0 seconds turns gated measurements off. Other values
activate the gated trigger function.
To perform gated measurements, the trigger source must be dif-
ferent from IMMediate.
Range: 31.25 ns to 30 s
*RST: 0 s
SENSe:LIST:POWer:SET ON,OFF,OFF,EXT,POS,10US,
434US
OFF
SENS:LIST:POW:STAT OFF
............................................................................................... 821
.................................................................................................. 821
.................................................................................................... 821
...................................................................................................821
...................................................................................................821
............................................................................................................. 822
Remote Commands in Spectrum Analyzer Mode
"Trg/Gate Source"
Remote Control
on page 375.
820