R&S ESR Series User Manual page 956

®
R&S ESR
Manual operation:
[SENSe:]CORRection:TRANsducer:SELect <FileName>
This command creates or selects a transducer factor.
Parameters:
<FileName>
Example:
Manual operation:
[SENSe:]CORRection:TRANsducer[:STATe] <State>
This command turns a transducer factor on and off.
Before you can use the command, you have to select a transducer factor with
[SENSe:]CORRection:TRANsducer:SELect.
You can turn on up to 8 transducer factors at the same time.
Parameters:
<State>
Example:
Manual operation:
[SENSe:]CORRection:TRANsducer:UNIT <Unit>
This command selects the unit of a transducer factor.
Before you can use the command, you have to select a transducer factor with
[SENSe:]CORRection:TRANsducer:SELect.
Parameters:
<Unit>
Example:
Manual operation:
User Manual 1175.7068.02 ─ 12
See "Defining characteristics of a transducer factor"
on page 508
String containing the name of the transducer factor.
If the name does not exist yet, the R&S ESR creates a trans-
ducer factor by that name.
See "Designing a transducer factor"
See "Using transducer factors or transducer sets"
See "Defining characteristics of a transducer factor"
on page 508
ON | OFF
*RST: OFF
See "Designing a transducer factor"
See "Using transducer factors or transducer sets"
String containing one of the following units:
DB | DBM | DBMV | DBUV | DBUV/M | DBUA DBUA/M | DBPW |
DBPT
*RST: DB
See "Designing a transducer factor"
See "Defining characteristics of a transducer factor"
on page 508
Remote Control
Using Transducers
on page 949.
on page 508
on page 949.
on page 508
on page 949.
953