R&S ESR Series User Manual page 849

®
R&S ESR
Manual operation:
DISPlay[:WINDow<n>]:TRACe<t>:Y[:SCALe]:RPOSition <Position>
This command defines the position of the reference level on the display grid..
Suffix:
<n>
<t>
Parameters:
<Position>
Example:
Manual operation:
INPut:ATTenuation:AUTO <State>
This command automatically couples the input attenuation to the reference level (state
ON) or switches the input attenuation to manual entry (state OFF).
Parameters:
<State>
Example:
Manual operation:
UNIT<n>:POWer <Unit>
This command selects the default unit.
The unit is the same for al measurementl windows.
Parameters:
<Unit>
Example:
Usage:
User Manual 1175.7068.02 ─ 12
Remote Commands in Spectrum Analyzer Mode
See "Ref Level Offset"
.
Selects the measurement window.
irrelevant
0 PCT corresponds to the lower display border, 100% corre-
sponds to the upper display border.
Range: 0 to 100
*RST: 100 PCT = frequency domain, 50 PCT = time
domain
Default unit: PCT
DISP:TRAC:Y:RPOS 50PCT
See "Ref Level Position"
See "Reference Value Position"
ON | OFF
*RST: ON
INP:ATT:AUTO ON
Couples the attenuation set on the attenuator to the reference
level.
See "RF Atten Auto" on page 354
DBM | V | A | W | DBPW | WATT | DBPT | DBUV | DBMV |
VOLT | DBUA | AMPere
*RST: DBM
UNIT:POW DBUV
Sets the power unit to dBm.
SCPI confirmed
on page 354
on page 355
on page 478
Remote Control
846