R&S ESR Series User Manual page 915

®
R&S ESR
Suffix:
<n>
<generator>
Parameters:
<Source>
Example:
Mode:
Manual operation:
SOURce<n>:EXTernal<generator>[:STATe] <State>
This command activates or deactivates the external generator indicated by the suffix
<generator>.
This command is only valid for the External Tracking Generator option (R&S FSV-B10).
Suffix:
<n>
<generator>
Parameters:
<State>
Example:
User Manual 1175.7068.02 ─ 12
Remote Commands to Control the Tracking Generator
.
irrelevant
1 | 2
tracking generator
For Noise Figure measurements (K30): 1 only
INTernal
the internal reference is used
EXTernal
the external reference is used; if none is available, an error flag
is displayed in the status bar
EAUTo
the external reference is used as long as it is available, then the
instrument switches to the internal reference (Spectrum mode
only)
*RST: INT
SOUR:EXT:ROSC EXT
Switches to external reference oscillator
A, NF
See "Reference" on page 491
.
irrelevant
1 | 2
external generator
ON | OFF
*RST: OFF
SYST:COMM:RDEV:GEN1:TYPE 'SMP02'
Selects SMP02 as generator 1.
"SYST:COMM:RDEV:GEN1:LINK TTL"
Selects GPIB + TTL link as interface.
"SYST:COMM:RDEV:GEN1:ADDR 28"
Sets the generator address to 28.
"SOUR:EXT1:FREQ:SWE ON"
Activates the frequency sweep for generator 1.
"SOUR:EXT ON"
Activates the external generator
Remote Control
912