R&S ESR Series User Manual page 186

®
R&S ESR
Unit
dBµV
dBµV/m
dBmV
dBµA
dBµA/m
dBpW
dBpT
The conversion to 1 MHz bandwidth is realized via the pulse bandwidth of the selected
resolution bandwidth.
Example:
Conversion example for dbµV:
P[dBµV/MHz
P = Displayed level
B = Pulse bandwidth of the selected RBW
imp
If you are using another unit, replace "dBµV" with the corresponding unit.
The conversion is also possible when a transducer defines the used unit.
Remote command:
CALCulate<n>:UNIT:POWer
Grid Range / Grid Min Level
Defines the scale of the vertical diagram axis.
The display ranges go from 10 to 200 dB in 10-dB steps. Invalid entries are rounded off
to the nearest valid value.
"Grid Range"
"Grid Min
Level"
Remote command:
Defining the range of the grid:
DISPlay[:WINDow<n>]:TRACe<t>:Y[:SCALe]
Defining the minimum level displayed on the axis:
DISPlay[:WINDow<n>]:TRACe<t>:Y[:SCALe]:BOTTom
User Manual 1175.7068.02 ─ 12

B

  
] P[dBµV] 20 log


on page 667
Defines the level display range for the scan diagram.
Defines the minimum level of the display range.
Common Measurement Settings
Relative unit
dBµV/MHz
dBµV/mMHz
(Available for active transducers only.)
dBmV/MHz
dBµA/MHz
dBµA/mMHz
(Available for active transducers only.)
dBpW/MHz
dBpT/MHz

[MHz]
imp


1 MHz

on page 844
Receiver Mode
on page 667
183