R&S ESR Series User Manual page 201

®
R&S ESR
150 kHz Highpass Filter
Turns the highpass filter avaiable with the R&S ENV216 network on and off.
For more information see
Remote command:
Highpass filter for the scan:
INPut:LISN:FILTer:HPAS[:STATe]
Highpass filter for the final measurement:
[SENSe:]FMEasurement:LISN:FILTer:HPAS[:STATe]
5.4 Common Analysis Functions
5.4.1 Trace Configuration
The TRACE key is used to configure the data acquisition for measurement and the
analysis of the measurement data.
The R&S ESR is capable of displaying up to six different traces at a time in a diagram.
A trace consists of a maximum of 691 displayed measurement points on the horizontal
axis (frequency or time). If more measured values than measurement points are availa-
ble, several measured values are combined in one displayed measurement point.
The trace functions include the following:
●
Display mode of the trace
For details on trace modes see
●
Evaluation of individual measurement points of a trace. For details on detectors
see
To open the Trace menu
●
Press the TRACE key.
The "Trace" menu is displayed.
Further information
●
Chapter 5.2.3, "Trace
●
Chapter 5.2.2,
●
Chapter 6.3.1.6, "ASCII File Export
Tasks
●
Chapter 6.3.1.2, "Configuring
●
Chapter 6.3.1.3, "Specifying the Trace
The following table shows all softkeys available in the "Trace" menu. It is possible that
your instrument configuration does not provide all softkeys. If a softkey is only available
User Manual 1175.7068.02 ─ 12
Chapter 5.2.5, "V-Networks Control
Chapter 5.2.2, "Detectors",
Modes",
"Detectors",
on page 685
Chapter 5.2.3, "Trace
on page 167.
on page 171
on page 167
Format", on page 399
Traces", on page 395
Settings", on page 397
Receiver Mode
Common Analysis Functions
(LISN)", on page 173.
on page 684
Modes", on page 171.
198