R&S ESR Series User Manual page 761

®
R&S ESR
Manual operation:
Configuring List Evaluation
The following commands configure the list evaluation.
●
CALCulate<n>:PEAKsearch|PSEarch:MARGin
●
MMEMory:STORe<n>:LIST
CALCulate<n>:PEAKsearch|PSEarch[:IMMediate]
CALCulate<n>:PEAKsearch|PSEarch:AUTO
CALCulate<n>:PEAKsearch|PSEarch:PSHow
CALCulate<n>:PEAKsearch|PSEarch:SUBRanges
CALCulate<n>:PEAKsearch|PSEarch[:IMMediate]
This command switches the spurious limit check off.
If you want to read out the values peak values including the delta to a limit, you have to
switch on the limit again.
This command is only for FSP compatibility, and not necessary to use on the
R&S ESR.
Suffix:
<n>
Example:
CALCulate<n>:PEAKsearch|PSEarch:AUTO <State>
This command activates or deactivates the list evaluation.
Suffix:
<n>
Parameters:
<State>
Example:
Manual operation:
CALCulate<n>:PEAKsearch|PSEarch:PSHow
This command marks all peaks with blue squares in the diagram.
Suffix:
<n>
User Manual 1175.7068.02 ─ 12
Remote Commands in Spectrum Analyzer Mode
See "Transd. Factor" on page 291
on page 777
.................................................................... 758
.................................................................. 758
.
irrelevant
CALC:PSE
Starts to determine the list.
.
Selects the measurement window.
ON | OFF
*RST: ON
CALC:ESP:PSE:AUTO OFF
Deactivates the list evaluation.
See "List Evaluation (On/Off)"
See "List Evaluation (On/Off)"
.
Selects the measurement window.
on page 680
............................................................ 758
........................................................... 759
on page 264
on page 293
Remote Control
758